2X2.5+E:Max. DC Resistance at 20 Degree 7.41 Ohm/Km
2X1.5+E:Max. DC Resistance at 20 Degree 12.1 Ohm/Km
2X4+E:Approx. Overall Diameter 14.0X6.5mm
Trademark: KAIQI POWER
Packing:100m Per Coil
Standard:As per Standards AS/NZS 5000.1
Production Capacity:10X20′gp Per Month
2 core & earth flat TPS cable Low voltage LV 450/750V 2 core and earth Flat TPS cable
These products are offered to AS/NZS 5000.2 (450/750V) or the more robust construction of AS/NZS 5000.1 rated at 600/1000V.
This particular range of cables is popularly known as TPS or tough plastic sheathed cables and can be split into two categories.
Flat TPS trades some of the toughness for an easi peel sheath and is commonly used for the fixed wiring of domestic and industrial lighting, power outlets, and heating.
Circular TPS retains the tough plastic sheath and is more commonly used for commercial and industrial wiring to motors, heating, and lighting, and areas where glanding is required.
CONDUCTOR Conductors consist of plain annealed copper.
INSULATION Cables should never be bent to a small radius. The prescribed minimums on the following datasheets should be considered the exception rather than the rule and the actual bending radius the largest which circumstances will permit. A cable must also not be laid or otherwise bent when it is at such a low temperature that damage might be caused to the insulation or serving. Where environmental conditions are at or below 0° C, cable drums will require heating, or drums stored on a site with a higher ambient temperature, and moved and installed as quickly as possible before significant cooling can take place. Cables can be pulled into position by hand, cable stocking or conductor hauling eye but for high pulling tensions a hauling eye is preferred to avoid stretching of the outer layer.
APPLICATION Easi-peel sheath for general wiring, unenclosed, enclosed in conduit, in underground ducts for domestic, commercial and industrial installations where not subject to mechanical damage. Suitable for single phase applications requiring neutral and earth.
STANDARD: AS/NZS 5000.1 VOLTAGE: 450/750V CONDUCTOR: Copper INSULATION: PVC, V-90 Red, Black & Yellow/Green SHEATH: PVC, 3V-90 NORMAL OPERATING: TEMP. 75 degree C.
TECHNICAL SPECIFICATION AS BELOW
Active conductor (Phase conductor)
Nominal overall Diameter (major x minor)
Max. D.C resistance at 20 ºC (Ω/km)
Approx. mass (Kg/km)
Nominal area mm 2
Nominal area(mm 2 )
9.1 x 4.3mm
10.2 x 4.7mm
12.4 x 5.5mm
14.0 x 6.5mm
15.2 x 7.1mm
18.6 x 8.5mm
21.5 x 9.7mm
Luxing Cable Factory
Luxing Cable Factory Mainly Produce
300/500V 450/750V electrical wire
600/1000V PVC insulated cable
600/1000V XLPE insulated cable
1.8/3KV to 26/35KV power cable
Armored underground cable
Control cable and instrumentation cables
Type Test Report
Packaging & Shipping
1.Are you a factory or a trading company?
We are a factory.
2.Can you provide free samples?
Yes, we can provide free samples of our products, just contact us with the details of samples needed.
3.What's the MOQ requirements of your products?
Our MOQ requirement depends on actual size and cable type